With powder, it's short-lived, and it's much more important for the air to escape in any powder spray booth than with paints, which you do on solvents. This is useful if you are looking at the economy, media, and manufacturing successive areas of work. Since the air must be replaced by less than warm air, in workshops, a little dust may collect, and little remains, from the airflow of workers. Using 95% powder with powder, material loss can be enjoyed, less than 5%. Any spray medicine can be reused, and the reused powder mixture can be used with raw powder. Save up to 95% usage. With powder, Korean is manageable. It can control the layer of coatings that require more than a traditional system. There are also some types of powder, which have a small layer thickness, which provide FEIHONG coatings. Powder offers a wide range of coatings and effects. Whether harvested for decoration, or for cutting jobs, seeds provide a useful solution. There is a wide range of colours, soft touch, textures, metallic finishes, satin finishes, matte finishes, and more. Operational properties vary, ranging from corrosion resistance, antibacterial resistance, etc. Powder requires less than the copies of Dexlene needed by powder workers; For much less training on electronics, which is solvent. Powder detergent is more used to using powder, a more used method for the wet game. The lips can be cleaned quickly and easily using a scraper or a rubber squeegee, while natural air is evacuated into the chamber. Cleaning brushes or air hoses should not be used; To do that. Any scope can be removed from the powder outside the isolation, four-wheel drive vacuum cleaner with an air-directed motor, or controlled against it. Lower cost in the plant that uses powder. The plant that uses powder, whether manual or automatic, is very easy to operate and lower in cost than any dual-engine electric fuel system. Powder is flexible - easy to use paint to dilute metals. Suitable for plating metals. Surface such as glass, hydrated molds can also be coated at a specific temperature required for the powder solidification process. More materials can be used where they are available, rather than weak techniques